[PUB] Use of Intuy Knee

0 %

Course content

How to Toggle Options ON/OFF?

Introduction

Several features are designed as options. For example,

Some users might not need cycling, and some users might struggle with the Holding function. They can simply turn them off.
Features from Extra software pack, such as E-Stairs, E-Descent, and E-Gait, are default toggled OFF, since these features require training before using. They should only be enabled until the user is trained and proficient at them.

Note: These options are only available from Intuy app v. 4.10.2 or higher. Learn more about how to update the Intuy App here: link.
Note: Screenshots used in this article are from a Intuy Knee PRO device, some features will not be listed for other devices. Learn more about software packs available per product here.

Where to find these Options?

Open the Intuy App,

SETUP tab-->Options accordion

Toggle button:

When a function is disabled, the button will be red and have "OFF" written on it, as shown below.

When a function is enabled, the button will be green and have "ON" written on it, as shown below.

Stair mode

Turn off stair mode

1. Open Setup tab.
2. Tap to open the Options accordion.
3. Tap on Stairs toggle to switch off the function.

4. Stair function is off.

Why Stairs toggle is greyed out?

If a CPO disabled Stair Ascent in the Extra Parameters accordion, the Stairs toggle will be greyed out.

After tapping on the toggle, a pop-up will appear, indicating a limitation.

A CPO can remove this limitation:

1. Setup tab--> Extra Parameters accordion:
2. Increase Stair ascent sensitivity.
2. Tap the save button in the top right corner.

After the CPO has enabled the stair ascent, the toggle will be set to off.

User can now toggle the Stairs function on.

Holding mode

1. Open Setup tab.
2. Tap to open the Options accordion.
3. Tap on the Holding toggle to switch off the function.

4. Holding function is off.

Cycling mode

1. Open Setup tab.
2. Tap to open the Options accordion.
3. Tap on the Cycling toggle to switch off the function.
4. Cycling function is off.

In the Dashboard tab, the Cycling button will be greyed out and disabled.